YP78 Glass fiber reinforced plastic hydraulic press
YP78 Glass fiber reinforced plastic hydraulic press
Pengda Fiberglass Hydraulic Press
Model:YP78
Options

Safety Light Curtain, Limit Sensor, Lower Lead Point Locating Device, Oil Temperate Cooling Device, Die Change Trolley, Die/Try-out Press, Front/Rear/Left/Right Moving Bolster, Upper Table 90º/180º/Front/Rear/Left/Right Roll-over, Mould Heating & Cooling System etc.

Product Introduction
Characteristics:
1. Computer optimized design, four-post structure is simple, economical and practical; frame structure rigidity, high precision anti-side load capability.
2. High parallelism between slider and working table.
3. Hydraulic control with cartridge-based systems, reliability, long life, small hydraulic impact, reducing the connecting pipe and the leak point.
4. Fast idle running speed, prevent material solidify; after pressing, slider separate with die slowly, prevent product tear and damaged.
Application:
Drawing, bending, flanging, and blanking for SMC, DMC, GMT, LFT-D etc. products.

Technical Parameters:

Type Unit   100T 200T 315T 500T 630T
Nominal force KN   1000 2000 3150 5000 6300
Maximum working pressure of the fluid Mpa   25 25 25 25 25
Slider stroke mm A 600 800 800 1200 1200
Maximum opening mm B 900 1200 1200 1600 1600
Eject stroke mm C 150 170 180 180 180
Pre stress KN   315 630 1000 1500 2000
Opening force KN   200 400 630 1000 1250
Stripping force KN   100 200 500 500 500
Down speed Mm/s   80 120 200 200 200
Working speed Mm/s   1-6 1-6 1-6 1-6 1-6
Return speed Mm/s   80 80 80 120 120
Pre stress speed Mm/s   6-25 6-25 6-25 6-25 6-25
Opening speed Mm/s   2-20 2-20 2-20 2-25 2-25
Release rate Mm/s   5-20 5-20 5-20 5-20 5-35
Table size L-R mm D 710 900 1200 1400 1600
F-B mm E 580 900 1200 1400 1600
Motor power KW   11 18.5 30 45 75